What are the various methods for effecive earthing in a
factory in a rocky terrain, where soil resistivity is
extraordinarily high? The usual method of 3 m deep earth
pits is not serving the purpose.
- 4 Answers
- 11471 Views
- I also Faced
- E-Mail Answers
Answer Posted / joby
here the soil resistivity is high. so mat earthing is provided
| Is This Answer Correct ? | 15 Yes | 4 No |
Post New Answer View All Answers
what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
Can anyone please give me the parameters , formula needed to calculate the circuit breakers for building services.Thanks
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
Why do we need interlocking in a HT metering or Ring main unit switchgear?
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
explain working principle of earth leakage relay
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
How to convert 2 phase to 3 phase electricpower in induction moter?
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
What is the difference between single core 2 wire and single core 3 wire system? Which application we are using this? and for What purpose we are using this?
what is the electrical?
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
Use of switch mode power converter in real-time basis?
where we use the SFU & FSU?
What happen if 200 KVAR capacitor connected to power continuesly?
