Interested to Buy Any Domain ? << Click Here >> for more details...
How can we calculate the fault level of the distribution
system knowing the percentage impedance of transformer &
subsequent equipments.
- 14 Answers
- 60512 Views
- I also Faced
- E-Mail Answers
Answer Posted / kaustubh
if we known the pesentage of impedance then by using this
formula we can calculate the fault Lavel.
fault lavel in MVA= Rated KVa/% of Impedence
OR
Fault Lavel= 1.732xFault Currentx Rated Voltage
| Is This Answer Correct ? | 146 Yes | 38 No |
Post New Answer View All Answers
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
What is PEC??Applications........
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
how give earthing conection to household equipment?
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
What do you mean by cogeneration? What its working principle?
WHat is the general checks required for Dry type transformers
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
how we calculate torque ? how we improve it ?where torque will either motor or generator ?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
what is the use of sdf?
I completed iti in2004 I was worked in A grade contractor can I get c licence
