As a system administrator, you want to debug igrp but are
worried that the "debug IP igrp transaction" command will
flood the console. What is the command that you should
use?
A. debug IP igrp event
B. debug IP igrp-events
C. debug IP igrp summary
D. debug IP igrp events
- 1 Answers
- 5962 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: D
The "debug IP igrp events" is used to only
display a summary of IGRP routing information. You can
append an IP address onto either command to see only the
IGRP updates from a neighbor.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is default size of hello packets in ospf?
How many parts of ping?
Explain isakmp ?
Default packet size of ipv6?
What are the steps of conversion for data encapsulation?
Which cable called roll-over?
What will be the prefix length of 224 in vlsm?
What are the different types of network in ccna?
What is the minimum and maximum request timer?
Which protocol used before part of ccna?
Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0
Which type of transmission bus topology support?
What is the draw back of ospf protocol?
Can you explain in a generic manner the packet of IPSec?
In which ios version 182 people can access router through telenet?
