Interested to Buy Any Domain ? << Click Here >> for more details...
You want to enable both arpa and snap encapsulation on one
router interface. How do you do this?
A. The interface can handle multiple encapsulation types
with no extra configuration.
B. Assign two network numbers, one for each encapsulation
type.
C. Enable Novell-ether to run multiple encapsulation types.
D. Both arpa and snap are enabled by default so you don't
have to configure anything.
- 2 Answers
- 28326 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: B
To assign multiple network numbers, you usually
use subinterfaces. A sample configuration follows:
ipx ethernet 0.1
ipx encapsulation novell-ether
ipx network 9e
interface ethernet 0.2
ipx encapsulation sap
ipx network 6c
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
State the difference between dynamic IP and static IP addressing?
How does PPP use LCP for link control?
What is poe (power over ethernet)?
Why subnetting is used?
Tell me how many reserve ports?
What is mtu and what is its size for transmission?
Explain what is eigrp?
What is window in networking terms?
What are the different memories that are used in a cisco router?
Can you give an overview of various components in IPSec?
Explain the difference between arp and rarp?
How many collision domains are in switch?
What is Transport and Tunnel mode?
What is trigger rip and from which ios version it starts?
Tell me how many hop counts are by default and how much you can increase in eigrp protocol?
