how to reduce power loss when the tranmission under long
distance?
- 19 Answers
- 21915 Views
- I also Faced
- E-Mail Answers
Answer Posted / sandy
Increase the transmission voltage. Naturally the current
will go down.
| Is This Answer Correct ? | 16 Yes | 4 No |
Post New Answer View All Answers
hi pal, i am vengatesh from tamilnadu(chidambaram),i have called for the written test for the post of jr executive(ELECTRICAL) of AAI ,I dont know about the question paper pattern,so any kindly help me to face the examination,post me the model question papers and some tips to write my examination to (vengi.annadurai@gmail.com)
what is the difference between single ratio, multiple core and multiple ratio, multiple core ? please explain.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
What are the causes for the failures of sandwich type (Al) busducts?
why induction motors are rated at 0.8 power factor.
What is line resistance of cable & how it can be measured ?
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
Benifits of 3ph 4 wire metering over 3ph 3 wire
-How do you select cable size for a given load at a given distance from source of supply. How do you find voltage drop.
Why AC current leads voltage in capacitor and how?
what is negative d.c. voltage, why this voltage is used in base transciever station.
what are the factors to be considered while design the breaker either HT or LT??
what is the difference between gas group b and gas group c electrical equipment construction wise?
if we install two earth pits with a clear space of 5m without any interconnection,by checking the digital multimeter will it show continuity between earth pits? If so what would be the approx. value
