What is the function of trip neutral close switch?
- 11 Answers
- 66266 Views
- I also Faced
- E-Mail Answers
Answer Posted / ravi kumar
TNC switch is nothing but two position switch. when it is
in close position it will put the circuit breaker in
operation by energising the closing coil and when it is in
trip position it will trip the circuit by energise the trip
coil in circuit breaker.
| Is This Answer Correct ? | 77 Yes | 15 No |
Post New Answer View All Answers
Z transform is use when system is not a) converges b) diverges
what is ATS & RING MAIN UNIT in Distribution System?And its Function.
How we can calculate the Amps for the cable Ex:- For 1sqmm wire how many amps we can draw (calculation)
What is current divider rule (cdr)?
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
What is reactive power and where it is used.
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
how to interlock 3 incomer-ACB,1 buscoupler ACB,... pls answer this question and if possible send me the ckt diagram..haifriends2910@gmail.com
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
pls tell me about ups internal connection & we have given only 3 phase supply to ups system how get 4 wire (R Y B N )
how many types of motor can be used in washing machine
Comment on the working principle of operation of a single-phase transformer.
how to failure indution motor insulation & how to improve heat in motor insulation
What is the use for cable entry in control room?
