what is the difference between the electrical and
electroncis
- 15 Answers
- 17614 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / saurabh
The term electrical engineering may or may not encompass
electronics engineering. Where a distinction is made,
electrical engineering is considered to deal with the
problems associated with large-scale electrical systems
such as power transmission and motor control, whereas
electronics engineering deals with the study of small-scale
electronic systems including computers and integrated
circuits.[1] Another way of looking at the distinction is
that electrical engineers are usually concerned with using
electricity to transmit energy, while electronics engineers
are concerned with using electricity to transmit
information.
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
What is the necessary and sufficient condition for stability.
What is Phase margin?
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
HOE WE CAN IMPROOVE BY USE OF CAPACITOR
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
how does it help for selection of a transformer.
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
Hi everyone. Some Generators uses 3-Pole breakers with extra contactors for Neutral. Some uses 4-Pole. Why so? What is the idea behind this? Thanks in advance for the solution. Kr.
if flux and load static in dc motor and supply voltage increases 20% then what happened in speed
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
why various test are performed on electrical panels & power cables before commissioning on site & what are these test???
Types of test in Switchgears, MCC, NGR and DB's how it should be procced. Can anyone give me the details here or email me to pasuvaraj.k@gmail.com
What happen to generator if i have unbalanced load?
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
