Interested to Buy Any Domain ? << Click Here >> for more details...
wht do u mean by load in circuit.wht dp u mean by inductive
load
- 7 Answers
- 15439 Views
- SGS, I also Faced
- E-Mail Answers
Answer Posted / gnanbalaji
All electrical equipments
motor,lights,transformer,etc..connected across a source is
called as load.An element which doesn't allows sudden
changes in current is an inductive load.
| Is This Answer Correct ? | 17 Yes | 2 No |
Post New Answer View All Answers
Dear all i am kumaravel. now in chennai. my work is control and relay panel auto cad designing.up to 11kv to 400kv then question is i am improving my knowledge. i want some books name and auther are available for this C&R panel related. plese any one help me
star delta starter contorl circuit... drawing..
Explain about technical and non technical losses in distribution system?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
before synchronizing an alternator,power factor is leading ,why?
How can we measure earthing resistance test (Earth meggar) of Transformer neutral pit while in live condition?.
Why is better to have a minimum ceiling voltage of 250% than 160%?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
How to calculate multiplication factor in kva example 500kva ans pls ?
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
Dear all, i completed M.E(Power Electronics & Drives) 2011 passed out having 78% so i need job in core side but i don't know how can i receive the calls from electrical companies and i uploaded my CV in naukri, times jobs etc.. In that iam not recieved any mails from good companies so give me best procedure plzzzzzzzzzzzzzzzzzzzzzzzz..... Thanks, K.Linga Reddy Email-id:-lingareddykmthm@gmail.com Ph no:-08015402078
we have provided 30 nos. relay contacts in panel.I want to know how do we do the numbering for the relay contacts as per any applicable standards
How to calculate VCB rating for 33KV ,25 MW Power line?
why ups rating in kva? and why ups are in parellel?.why isolation transformer is used in ups?
Grid fault level [KA]?
