Interested to Buy Any Domain ? << Click Here >> for more details...
can anybody provide me the HPCL apptitude papers?am having
the test on this feb 19th 2008 so plz
- 3 Answers
- 6604 Views
- HPCL, I also Faced
- E-Mail Answers
Answer Posted / balakrishnan
HPCL is send the model Question and test center.so,don't
feel it.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
What are the requirements of a good fuel?
What is the principle of a pump?
Explain what is torque?
Define emissivity.
Hello sir, I am Rajaram. I have finished DME (Diploma in Mechanical Engineering). I would like to attend BHEL supervisor examination. So i want which type of questions can i prepare. & give previous supervisor examinations questions. Reply my mail (rajaramsptc@gmail.com)
Identify the parts of indicator diagram?
Name the operation which can be performed by lathe machine?
What is comprehensive definition of compressor surging
what's the difference between front and rear wheel drive?on what basis we choose the type of drive?
Explain how are the pneumatic system and the hydraulic system similar?
i am a mechanical engg.8th sem student.i want to know the syllabus and criteria,previous question paper set of section engg(RLY).please send it to my email id.pleaseeeeeeeeeeeeeeeeeeeeeee
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What type of boiler does not need a steam drum ?
Where mixed flow type compressors are used?
DIFFERENCE BETWEEN CODES,STANDARDS & SPECIFIFCATIONS?
