Interested to Buy Any Domain ? << Click Here >> for more details...
what is reset windup in integral control?
- 6 Answers
- 31075 Views
- Honeywell, I also Faced
- E-Mail Answers
Answer Posted / bhuvana
Integral controller is nothing but a reset controller
reset means , come back to the initial (zero)condition
reset windup means not allowing the controller to the
initial condition
| Is This Answer Correct ? | 12 Yes | 21 No |
Post New Answer View All Answers
How to calibrate level transmitter with use of HART?
Draw bode plot of any transfer function. Why is plotting bode necessary?
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
How it the difference between force balance system and dispalacement balance system?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
what is 24vdc live and dry supply
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
What is the purpose of bypass valve across AS valve.
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
