"you r graduated as ELECTRONICS AND COMMUNCATION ENGINEER,
then y u r looking for a job in IT side"?
Answer Posted / jayaprabhakaran.k
though ihave done ECE i am not that much strong in
that,because my preparations were in exam point of view ..i
have done done a couple of software courses as part time i
beleive i can do it....
Is This Answer Correct ? | 6 Yes | 17 No |
Post New Answer View All Answers
How much losses in microwave Link?
What are the questions that are asking at iris aptittude question paper
Describe transducer ei pickups in instrumentation and control engineering?
what is the minimum and maximam trace width in PCB design? why trace is measured in mils? what is the use of via? why the crystal oscillator is placed near chip?
what is the operation involved in tubelight?
Power bjt is a current controlled device. Why?
What is the need for load flow study?
Define positive logic and negative logic.
The function of a transistor used in any of the ics is to perform switching action and not amplification. Then why diodes are not used instead of transistors as diodes also exhibit the same switching action?
What is meant by step-up and step-down chopper?
What are the main components of AMF panel. Is it required to use ATS in LT panel if DG is used as stand by supply? Please send any single line diagram showing AMF & LT panel etc., if possible please send to sreenu_207 @ yahoo.co.in
Which type of power plant is more easier to produce electrical power at economical condition?
What is commutation angle or overlap angle?
define drain resistance
Can we get light when the circuit is working?