How to calculate the size of the conductor for particular
load
- 9 Answers
- 25774 Views
- Eskom, HCL, I also Faced
- E-Mail Answers
Answer Posted / ashraf majid
The size(cross sectional area) of the conductor for a
particular load not only depends upon the current drawn by
the load(nature of the load), it also depends upon nature
(resistivity) of the conductor material(i,e; whether the
conductor material is made of copper, silver or any other
material). It also depends upon the external physical and
environmental conditions.
| Is This Answer Correct ? | 43 Yes | 10 No |
Post New Answer View All Answers
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
what are the major & minor faults that occur in an inverter and in UPS ? And how to repair and resolve them ?
Safety of on line ups
How to select transmission line type (i.e. 11kv or 33kv) for new established industries
define hysteresis loss, eddy current loss and windage loss
What is electrical diversity factor in electrical installations?
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
how to test YNyn0 vector group in transformer?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
What is a copper loss or i2r loss pc?
What are the criteria shall be considers for sizing Fuse and MCB? If the rated current is 10Amps what should be the fuse size / MCB Size?
armature winding of dc machine produce alternating emf then it convert in to dc by using commutator.But only we consider armature resistance why don't we consider inductive reactane effect?
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
what is transient stability analysis means?
