condider as 100 w lamps glowing . for completing a one unit
how much time it should glow
Answer Posted / balakrishnan
As per basic electricity Concept 1 unit=1000 watts or 1KWH
Now we take 100 w/h load .Its mean it will
take 100w (electricity power consumed)by one hour and
respectively 200 w take two hours.....Finaly 1000w take 10
hours (without load interuption).
So it will take 10 hours
Is This Answer Correct ? | 29 Yes | 2 No |
Post New Answer View All Answers
Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.
What are gain margin and phase margin?
what is the vvvf in the dumbwaiter?? or lift. what is the actual process?/
Please tell me the formulaes while designing a substation for power Calculations in designing a 33 KV Substation?????
derive DC RMS value for half wave rectifier?
Define resonant frequency?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
Salient pole alternator is more stable, why?
nwhat are the main Components of servo motor?
How will be the single line diagram of series trip HT breaker? how it works?
Dears we deal in Chemical are Plate earthing. Kindly call if any requirement and questions. Tech Earth Solutions Mohit Verma 8791071007
what may the reason for vector shift in a generator?
The capacitive reactance of a capacitor of 1/(2(PI)) F at 10^3 H is
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
How is magnetic leakage reduced?