Answer Posted / guest

Cause: The FILESIZE parameter must be a multiple of the
RECORDLENGTH, but the value you specified for FILESIZE does
not meet this requirement. The value of FILESIZE has been
rounded down to be a multiple of the RECORDLENGTH used for
the dump file.

Action: No action is required. You can adjust the FILESIZE
or RECORDLENGTH parameter to avoid this message. When
importing this file, you must specify the FILESIZE value
reported by this message.

Please add more information about this Error

ORA-16516: The current state is invalid for the attempted operation.

8871

---

ORA-26082: load of overlapping segments on table string.string is not allowed

1813

---

invalid quantity specification negative quantity are not allowed for this item please check this item definition quantity

3435

---

if the lengths of two wires are same and the area of cross sections is 4:7 then what will be the ratio of current passing through these wires

2751

---

ORA-07497: sdpri: cannot create trace file 'string'; errno = string.

2855

---

ORA-16627: No standby databases support the overall protection mode.

4036

---

In my project I am using star schema and only diimension tables are loaded and not fact tables any one can help me why it is happening? Plase guide me.

2945

---

How to resolve QSM-01108 error. I have no OR conditions in my query, but do have 9 IN conditions. The error says the max limit is 2 while I have 257 number of disjuncts. However, if I remove even a single IN condition, the query is rewritten. I cannot change my query. How can I resolve this issue?

2760

---

Hi guys, I have four tables those are emp,dept,eliminate and uneliminate. i wrote small cursor..when i run, it display one error (ORA-01403 nodata found)... The query is: Declare cursor c1 is select e.ename emp_name from emp e,dept d where e.deptno=d.deptno group by deptno; r1 c1%rowtype; test_emp varchar2(200); begin for r1 in c1 loop begin select eliminate_emp into test_emp from eliminate t,uneliminate ut where t.number=ut.number and t.deptno=e.deptno and rownum<1; end; dbms_output.put_line(r1.emp_name); end loop; end; Thanks...

2659

---

when i ran any workflow or session, getting below error: seesion task instance[s_xxx]: Execution terminated unexpecterdly

2297

---

ORA-26076: cannot set or reset value after direct path structure is allocated

2029

---

ORA-26030: index string.string had string partitions made unusable due to:

1986

---

ORA-26095: unprocessed stream data exists

3635

---

ORA-26079: file "string" is not part of table string.string

1998

---

RMAN-05017: no copy of datafile number found to recover

2465

---