Answer Posted / guest
Cause: A flashback time was specified for the Data Pump job
which either could not be parsed or else could not be
translated into a system change number (SCN). This typically
occurs when
Action: Specify an explicit SCN for the desired flashback
rather than a time.
Please add more information about this Error
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
RMAN-05017: no copy of datafile number found to recover
When i am connect database through toad,one error occured. ORA-12514: TNS:listener does not currently know of service requested in connect descriptor. plz help me thanks advance.............
In my project I am using star schema and only diimension tables are loaded and not fact tables any one can help me why it is happening? Plase guide me.
ORA-07497: sdpri: cannot create trace file 'string'; errno = string.
ORA-26030: index string.string had string partitions made unusable due to:
ORA-16516: The current state is invalid for the attempted operation.
IMP-00060: Warning: Skipping table "string"."string" because object type "string"."string" does not exist or has different identifier
ORA-16627: No standby databases support the overall protection mode.
IMP-00063: Warning: Skipping table "string"."string" because object type "string"."string" cannot be created or has different identifier
ORA-26076: cannot set or reset value after direct path structure is allocated
ORA-16626: failed to enable specified object
ORA-26095: unprocessed stream data exists
Hi guys, I have four tables those are emp,dept,eliminate and uneliminate. i wrote small cursor..when i run, it display one error (ORA-01403 nodata found)... The query is: Declare cursor c1 is select e.ename emp_name from emp e,dept d where e.deptno=d.deptno group by deptno; r1 c1%rowtype; test_emp varchar2(200); begin for r1 in c1 loop begin select eliminate_emp into test_emp from eliminate t,uneliminate ut where t.number=ut.number and t.deptno=e.deptno and rownum<1; end; dbms_output.put_line(r1.emp_name); end loop; end; Thanks...
NZE-28868: Peer certificate chain check failed.
if the lengths of two wires are same and the area of cross sections is 4:7 then what will be the ratio of current passing through these wires
