Interested to Buy Any Domain ? << Click Here >> for more details...
What are IP protections used for electrical panels, JB, equipments installed in explosive zones like Petrochemicals, Oil & gas
- 1 Answers
- 2980 Views
- I also Faced
- E-Mail Answers
Answer Posted / ernesto matsimbe
IP (Ingress Protection) represents the level of protection the equipment has with regards to the immersion of moisture/dust etc... inside the equipment. Basically, where the equipment can be installed (Indoor/Outdoor). The higher the number the better it is.
For hazardous areas (HA) an accordingly EX rated equipment must be installed according to HA Classification (Zone 1, Zone 2 & Zone 3 for liquids and gases and Zone 21, Zone 22 & Zone 23 for dusts)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
explain comutator action in detail.thanks
what is the k var ratting of 1250kva
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
Single line diagram for dbb (double bus bar)system.
What is the lockout relay
What is warm / cold start of HT motors. How many warm start & cold start are possible in a day?
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
What happened when capacitor connect series in ac circuit?
i applied for c licence with my one year apperents trainee and i have attaced with A grade contractor company experiance that is for 14 monts experiance this document is sufeicant for c licence? pls tell why they rejected
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
What happens if i apply 500V to 440V rotary Switch ?
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
Explain the difference between verilog task and verilog function?
what is through fault?
