Can we use LT(150 sq. mm) cable in place of HT (120 sq.mm.) cable.?
- 1 Answers
- 1016 Views
- I also Faced
- E-Mail Answers
Answer Posted / manmohan singh
yes we can use it because the sq.mm cross sectional area is bigger than 120 if i am wrong please correct me.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is EMC filter in VVVF Drive ?
What is the difference between a fuse and a breaker?
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
Write masons gain formula.
why the NGR (neutral grounding resistor) always OFF during DG off?
what happen ehen synchronisation is done at below rated speed
How grounding is different than earthings?
how can we save enegry by using VFD for Resiprocating Air compressor which is having more unloading running hours
Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set
What is dynamo?How it works and what is the function of dynamo in a DG.
Explain about 3 phase motor fault current calculation with examples?
What is the function of electron gun used in crt?
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
what is two point starter?
what is the standard duration after failure EB power
