Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gamitsuresh
Ratio control widely used to control air fuel ratio in the field of process industries. Ratio control there is two flow.flow 1 and f2 f1 is called as uncontrol flow and f2 control flow..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Describe the function of Accumulator into the Pump
What is the reason PT speed not incresed in gas turbine?
how do we commission inergen system?
Why do we have earthing cable in branch cable and shield in the same cable?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
what will the sending unit in the fuel gauge utilizes?
Calibration of controller (pneumatic)
IN CONTROL VALVE SPECIFICATIONS GENERALLY TERM " DE- 200" ."DM -400"USED,, WHAT IS DE/ DM STANDS FOR?
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
How to calibrate Toxic gas detector?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
what is cems analyzer explain with principle and drawing ?
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
