Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ramandeep
There are many points in switchyard which are earthed,so to provide low resistance path,we should have to increase moisture in soil and when there is raining water easily absorbed by earth or soil which increases moisture and provide low resistance path by which fault current easily transfer to ground and the stones which are used at switchyard work as a insulation b/w wet soil and living body or human.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
Explain the working of variable frequency transformer?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
How to select, design,size & calculate for 11 KV/33KV/66KV/132KV/220 KV/440 KV circuit breaker for HT side of transformer protection/HT distribution protection?
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
from generating station If 400v LT line length is 1000m how much voltage is drop and how do i calculate it? which cable will be use for this line?
raleigh method
How good are you in resolving the commercial issues to Employer's advantage?
Write the programming software name for LG, SIEMENS,Messung,AB
mccb service sittings be done?
send me all basic electrical question and answers
What is thresh hold value of current?
design a 3 bit synchronous and asynchronous counter using T- flipflop
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
In siemens PLC, why do we want to move the data ?
