Interested to Buy Any Domain ? << Click Here >> for more details...
GWR radar transmitter working principle?
- 2 Answers
- 2834 Views
- Tata Steel Limited, I also Faced
- E-Mail Answers
Answer Posted / ravishankar s.
The principle of Guided wave radar transmitter works on the principle of time and travel. Radar wave travels at the velocity of light. The flying time is converted into level signal via the electronic units. The probe emits high frequency wave pulses which travel along a cable probe or a rod probe.
you can easily understood like transmitter and receiver.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
all types of liquid analyzer principle with drawing?
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
give some question relative instrument fitter?
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
What is Erosion in a control valve?
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
How to calibration a control valve?
