Interested to Buy Any Domain ? << Click Here >> for more details...
Why does
The speed of motor used in elevator remain constant irrespective of load??
- 1 Answers
- 2668 Views
- I also Faced
- E-Mail Answers
Answer Posted / adel hesham
Speed is inverse to torque and proportional to power
So if I need a fixed speed then torque and power should change proprtionaly to fulfill the required speed constant
Also using and encoder for speed feed back helps the vfd to produce the correct torque which fulfill the stored / required speed
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
List examples of voltage source?
what is difference between earthingpits,earthing grid & earthing mess?
what is ground fault in ACB?
what is conductor copnstant of ab cable
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
can you plz send l&t aptitude questions if available its urgent plz plz plz
Why do we need interlocking in a HT metering or Ring main unit switchgear?
Is phenomenon of resonance is harmfull fr the machine? if not or if yes please explain it?
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
how to control the speed to switched reluctance motor
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
What is meant by rotor?
can i use the six sigma method which is used in management area, in state estimation of power systems?
