Why the steam Turbines are Designed Higher side compare to Alternator
- 1 Answers
- 1330 Views
- I also Faced
- E-Mail Answers
Answer Posted / powerplant.calculations
As there will be loss in power in Gear box
net power generated = Total power generated X Turbine Mech.eff X Gear box eff X Alternator efficiency..
For detailed information on power generation..
May refer
https://www.powerplantandcalculations.com/2020/05/pmg-excitation-avr-power-generation.html
https://www.powerplantandcalculations.com/2020/05/understanding-of-heat-rate-and.html
www.powerplantandcalculations.com
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
LAPT working in alternator / generator
Which will have more strain energy 1.Spring 2.Circular disc 3.Solid square plate.
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
what is the basic use of power plant in equipment
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
why airtel use + 24 volts and other operators use -48 volt
How do you consider that you can improve and what assistance do you need to achieve this
what is the difference between compensated & normal drum level in boiler drum?
How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
can dp type level transmitter work in under vaccum condition
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
explain how the third harmonic content of the magnetising current affects transformer design
what is the trip circuit supervision in an electrical meaning?
