Interested to Buy Any Domain ? << Click Here >> for more details...
thermal power plants in steam using inlet of turbine.inlet
of turbine pressure and flow is same as boiler feedpump why
not use direct to turbine?
- 6 Answers
- 13419 Views
- IBPIL, JSW, I also Faced
- E-Mail Answers
Answer Posted / mayur mukaty
Specific heat of Water and super heated steam is different. turbine design Is so that it give max output with minimal Heat energy. As well Steam turbine Operation is base upon conversation of Thermal energy to Kinetic Energy. So come to point when We Direct put Water in to the turbine is Power consumption is so equally to Turbii Output that why its not fisible. Another thing is that compressibility factor but i did not go on that concern because It too long. term
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is natural frequency of turbine shaft .
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
can u please tell me how to calculate the concrete quantity for a under reamed pile? r=300mm,depth=3m for a cylinder and for bulb l=.750mm,width=.525
what's the moog valve
procedure of how to generate power in solar plant.
We have Demin Closed cooling water system with expansion tank for cooling oil system. Expansion tank having N2 bladder. Whenever N2 bladder bursts out, Closed cooling water circuit pressure drops and make-up happening, eventhough there is no leaks. And how Circuit pressure drops?
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
Which will have more strain energy 1.Spring 2.Circular disc 3.Solid square plate.
what does mean by kva rating
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.
How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.
How to calculate power press toneage
what is restricted earth fault explain in details
