What is the rating of your capacitor bank at your company.
- 36 Answers
- 75967 Views
- Ajnara Group, Amara Raja, Amol Electricals, Apollo, ATC, Bhagiradha Chemicals & Industries, Bharat, CBRE, Cisco, Government, JLL, MEIL, Reliance, Sterling, TNEB Tamil Nadu Electricity Board, Torrent Pharma, Victory, I also Faced
- E-Mail Answers
Answer Posted / ashishpalakkadan
The size of your capacitor bank will depend upon your load, existing power factor and your required power factor.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
What will happen if the armature resistance is in minimum position and the field resistance is in maximum position while starting the motor
what is the difference b/w ATS and HTS?
what is the use of expulsition protective gap in 11Kv line.
How can we findout the maximum efficiancy of Transformer? At which load?
why the arc welding machines require parallel earthing systems? ie why each machines are connected to earth pit by separate wires during earthing? wats it adavantages?
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
What is mean by Sensitive Earth fault & what are the effects
WHAT IS THE WORKING PRINCIPLE OF A GENERATER.how is a GTG (Gas TURBANE Generater) working.plz explane
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
how to calculate kvar in Akiva
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
