Answer Posted / bhupatmeer
Improper alignment in between motor and pump shaft.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is difference between start imitation and start interlock for 3 phase motor protection ?
What is the meaning of loop in transformer
Briefing the effects of ASR and ACR of a double closed-loop speed regulating system.
the typical output of a solar cell is........
What is the unit of charge and current?
What is meant by harmonic distortion?
transformer phasor diagram under load explain it?
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
Why does amplifier gain reduce?
How do I calculate a WTI CT ofa 1250kVA 6600/400V transformer
what r the checklist while installing 500 kva transformer
can we use NPT glands in LT panel
What is the drawback of class b amplifier?
power transmission pole used one support , that only for support or earthing
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
