Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vijith
It is a system to isolate any source of energy from its source for carrying out an operation( Maintenance or Modification Works) in its Energy flow line.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
how open delta PT works & what is its construction?
State and define norton’s theorem?
Why the standard of ambient teperature mentioned as 40 degree celcius in machines.
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
What is Auto Mains Failure Panel & Auto Synchronizing Panel
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
how we findout a ignater is faulty or not?
what is Fault level? why it is calculated? how will u decide same for our plant?
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
What is the importance of earthing?
what work will do diffrential realay DG set
What do you understand by external characteristics of a d.c. Generator?
how to calculate fault level?
