Answer Posted / 12354
Human body reacts to the current. The amount of damage will depend on the amount of current. However amount of current is directly proportional to the voltage. So high current is dangerous to human body bot it is caused due to high voltage or low body resistance(wet body condition)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
new 90kw motor installed so how I purchased cable ,fuse,etc please give me technic for cable selected why always capacitor delta connection
mention hazard experienced during installation
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
differnce between single acting and double acting solenoid valves
(In MEP services) HVAC in AC Plant room what else can we provide if the chiller is not considered?
how to work droop ct in generating station
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
What is an order of a system.
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
what is inter connected dc generator?
What is open loop and control loop systems?
How is the connection of the tap changer on the HV side been made?
what purpose to use excaiter in DG.?
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .