Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sabareeswaran
wter cooled chiller plant total 4 stages, frist commpressor high peresser and hig temprature vapor stage give to condonsor, condonsor vapor to liquid stage give to expenson value, expensonvalue lowpressor and low tempature give to evaprator, evaprator refireagnt to water
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why are lt windings placed near the core?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
What are the roles and responsibilities of electrical engineer in cement plant
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
why asa method ZPF method is more accurate than ASA method?
we use 400/5A ct and 35/roor3KV,/0.1/root3KV,0.1/root3KV pt ratio. What is the multiple factor of this meter.
How can we measure the residual voltage in dc machines?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
What is Icu and Ics and what is difference b/w them. please tell me how to calculate a size of a copper bar for a system or a breaker... reply on... king.arish@gmail.com would be waiting for a logical answer.
I need bhel electrical test pattern & paper
What is Negative Potential Bias
why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?
