what is the significance of 3.5 core cable? or what does this
half core mean and why is it required?
- 5 Answers
- 15317 Views
- I also Faced
- E-Mail Answers
Answer Posted / susheel kumar sharma
when there is balanced load in three core , there's no need to Use more than 3C but if there is unbalanced Load in circuits , there is used 3.5C in which 0.5C carry that unbalance current through it..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how is the cable tray designed & how its total length is calculated for an Industrial plant Say for Ex. (500KW Motor Load)
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
which of the following elements is not present in stainless steel
what is two point starter?
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
what is active power & reactive power?
Can you explain about Restricited earth fault protection scheme
how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?
Which motor will you choose which can operate in both lagging as well as leading power factors?
how can maintain the power factor and why and this is how do work tell us
What is control system?
How many kinds of E.L.C.B and how to work E.L.C.B
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
