Can a generator rated 400 V, 60 Hz be used in a 50 Hz System? Yes or No ? Why ?
- 1 Answers
- 1666 Views
- VECL, I also Faced
- E-Mail Answers
Answer Posted / zore mahesh baburao
No
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how you taken aotitude test
For a spring controlled governer the relation F = ar+b (F is the controlling force, r is the radius of rotation a and b are constants), indicates that the governer is
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
What is vacuum circuit breaker.define with cause and where be use it device?
What does the term supermesh means?
What is meant by Load Encroachment in OHL Feeder Protection?
Draw a SLD of HT distribution EB grid up to users Transformer?
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
what is the use of expulsition protective gap in 11Kv line.
why swinburnes test cannot be performed on series machines?explain
what kelvin's law ?
can anybody sent me power grid questions. what subject should i prefer for preparation?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
