Answer Posted / irfan ali
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the ignition temp. of Alluminium,Coper&Iron.
What are some characteristics of bulk solids that can affect their ability to flow properly?
What is a good approximation for the heat transfer coefficient of hydrocarbons inside 3/4" tubes?
What is higher heating value and lower heating value? Is it positive or negative?
What are the types of load?
Is it advisable to cool a fin fan by spraying demineralized water on it?
What is vapour flooding and liquid floodin in distillation?
What is critical radius of insulation?
X is a solid having a white colour at room temperature. It has a density about 2g/cc. Although it has melting point near 325 degree Celsius, its properties start degrading above 260 degree Celsius. The coefficient of friction is very low about 0.1. It has very good dielectric properties especially at higher radio frequencies. It has a very high bulk resistivity. It is chemically inert. It is also resistant to van der Waals force. It is hydrophobic as well as lipophobic. Creep or ‘Cold Flow’ has been observed in X.
What are the methods involved to test helium leak testing in a vacuum system?
How is plate heat exchangers used in an ammonia refrigeration system?
what is mean by chemical engineering and its scope in industry
Explain what is the best way to configure a bypass line in slurry services?
white rust formation over zinc plated and yellow passivated fasteners during CED painting. WHY?
Why in a continuous plant for a Hot standby screw pump system the interlock for auto starting of the other pump ( when the running pump stopped suddenly) is given with header pressure only? why not with flow rate or current of the pump?
