Interested to Buy Any Domain ? << Click Here >> for more details...
what is the safety of VCB.
- 5 Answers
- 32147 Views
- Nagarro, Roto Power, RotoPower, I also Faced
- E-Mail Answers
Answer Posted / arvind kumar
VCB SEFTY
Earth fault
Short circuit
Over current
| Is This Answer Correct ? | 38 Yes | 10 No |
Post New Answer View All Answers
What is the method to solve circuit using source transformation?
What is a system?
I want to do a mini project. Now I'm studying in 6th semis tor EEE Engineering.
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
why ten delta testing is carried out on power transformer
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
I need HT sphere gap calibration table. Can any body help me.
does any one know where we can purchase insulation oil for high voltage oil filled cables
what are the difference between AC lamp and DC lamp
State the types of distortions in amplifier?
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
What is block diagram?
what happen if drive input fail momentry at 48.5 HZ frequency?
