How can we calculate C10 rating of a bttery from c5 or c20
ratings??
- 1 Answers
- 5061 Views
- Intel, I also Faced
- E-Mail Answers
Answer Posted / mohandas
A 100AH battery when fully charged will be discharged at a rate of 5 Amps when it is at C20 rating.
Similarly at C10 rating the battery will be discharged at a discharge rate of 10 Amps when it is at C10 rating.
It will be the same way when the battery is being charged. At C 20 rating the battery will take 20 hrs to get fully charged at a charging current of 5 Amps.
However, these are theoretical assumptions and could vary with life of the battery.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
hr round
Why efficiency of generator is higher than motor at a particular load?
What is grid collapse? what is the reason for it?
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
What is an automatic controller?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
how to select energy meter? have any calculation?
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
Please sent me some previous year question papers of BSNL-JTO telecom and RRB in ELectrical Engineering to varshashahi@yahoo.com
what is reverse power relay brief explanation and in b/w where it is connected
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
What are the raitings of Mcb,mccb and Acb in detail ??
what is the ms flat constant for calculating earth mat design calculation?
WHAT ARE THE DISADTAGES OF SINGLE-WIRE-EARTH-RETURN SYSTEM USED FOR RURAL ELECTRIFICATION?
