What is the major difference between P.T. & C.V.T ? Why CVT
is used in HT Transmission line in place of P.T.?
Answer Posted / amit paul
Ferroresonance phenomenon may overcome in CVT with the filter circuit provided in parallel to the secondary circuit. Which is not possible in case of PT.
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
1)Explain why the cradle guard is used on railway crossing in overhead line construction?
What are the types of class b amplifier?
Where can I get CPWD electrical specifications & Shedule of rates? Please help me
What is shutdown of electrical sub station?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
What types of question are done for diploma students in aptitude test
please suggest some good universities with low cost iam in totally full confusion so please help me my profile gre 283 and ielts 5.5
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to reconfirm its base capacity.
How to calculate VCB rating for 33KV ,25 MW Power line?
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
what is the meaning of neutral displacement ???
impliment (AB)`+C to transistor representation
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
How to decide DO set rating of Transformer?