why core losses and copper losses does not depend on power
factor?
- 5 Answers
- 20660 Views
- I also Faced
- E-Mail Answers
Answer Posted / prabhakar jha
core loss is a variable loss in the core.due to alternating magnetic flux educed in core. copper loss is a constant loss its not depend in load & unload...
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
what rectifiers is and what are the types of rectifiers?
what is under coal gassification?
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
can the measured percentage error during calibration of single phase energy meter be negative?
how to carried out tan delta test in 11 KV alternator ?
How to check the LM324 Ic
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
What is the function of RCBO? What are the different sensitivity ratings & each application?
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
how rectifier transformer work in electroststic precipetatore(esp?
How can I calculate ISF of current transformer?
