why microprocessors are named as 8085 ,8086 etc?
what's the reason for this???
Answer Posted / omkar bhilare
Microprocessor is named as microprocessor becoz it was named by Mr wankhedde
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is transient response?
How many turns are there in primary winding? (In Transformer)
why we use single core 630mm2 cable for transformer secondary side
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
Is it true that in the 3 phase transformer, the limbs of the core are at 45 dgrees to each other. if true, why?
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
how to check three phase motor torque value?
Define average demand?
What is control system?
please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
Why the frequency of ac in india is 50 hz but in some other countries it is 60 hz.