Interested to Buy Any Domain ? << Click Here >> for more details...
In my 3 phase 4 wire electrical system
N to earth voltage is 0.08 is it ok
What is standard for it ?
- 1 Answers
- 2220 Views
- Kay Bee, I also Faced
- E-Mail Answers
Answer Posted / shilar shaik
0.08voltage is ok for that.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
Is electro plating what type of load whether resistive, inductive or capacitive loads
Define peak overshoot.
explain with diagram how to protect transformers and substations from over current with help of CT's?
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is speed mode?
What is the exact formula for one weber of magnetic flux?
what is positive , negative & zero equivalent system resistance
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
What is expention fastener (Fan)
What is the instrument to check the rotating diode fuse of alternator in running conditions?
i have 3500 amp load and select current transformer and perches.how i calculate .please understand
different aspects of voltage stability
