Interested to Buy Any Domain ? << Click Here >> for more details...
In transformer which temp should be less oil temp are
winding temp?
- 7 Answers
- 16897 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / pritesh
Obviously Oli temperature should be less than winding temperature because oil immersed tc oil basically use for heat dissipation and cooling so oil temp less
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
PAC and simple Ac different
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
What is primary and backup protection?
explain the what is a drive ? 0 4 which type motor r use in the celling fan..... PCB plannet 2 13 If stator & rotor of a 3-phase induction motor have different no. of poles, will the motor run or not?? types of drives Why dc supply is used for closing and tripping coil of ht breakers. What happen if we use only ups ac supply only. ACC 1 41 how the 3phase induction motor is running in 2phase supply with help of capacitor? 1 33 what is the actual difference betwen constructional details and constructional features? 1 20 how does commutator convert a.c to d.c?
What about electrical Units. discrive in detail
How can we convert 11 kv to 440 volt without using transformer ?
What is the role of Dedicated earthing in UPS System?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
why occ characteristics curve in not tracing back when we are bringing back the rhoestat?
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
why don't we use the generator as a motor? and what will happen?
how to calculate singlephase motor efficiency?
