what are the CAD software versions you have used?
Answer Posted / n.ramu
I am using 2013
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why we can use dust in concrete insted of fly ash
it is a corrected question." make a list of engineering property(properties) of soil.
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
i have boiler of 35 tone and wanted dig out foundation is there any body to help me to carry out calculation for the foundation like
If we buy crush sand for 3200/ Brass and cement for Rs350 /Bag and flyash 1200 / tonne....and my production is 230 Bricks per bag than how much cost is required for 1 flyash brick?
How to activate isometric axes in cad?
how can we calculate steel value, depending on load
why demand factor less then 1 ?
What do you mean by honeycomb in concrete?
What are some structures that may be subjected to fatigue?
What is construction mitigation management?
may i know the detailed description of cutting length
how to calclate the SHUTTERING TAKEN CONCRETE LOAD? WHAT IS THE LOAD BEARING CAPACITY IN STEEL SHUTTERING PLATE? WHAT IS THE CONCRETE LOAD IN (MASS) IN THE SHUTTERING PLATE. PLATE SIZE IS 120CM* 90CM CONCRETE WALL LENGTH IS 10M ,WIDE IS 60CM, HEIGHT IS 1.2M PLS TO SENT THE CALCULATION.
What are the points to be considered for calculating cement reconciliation. a)Do we need to deduct the wt of cement bags b)Do we need to adjust the qty due to wt loss during transportation, loading unloading etc or else each bag can be considered as 50 kg bag c)What is the proportion of mix cover block making.
How much cement will require for 1Rmt Skirting laying