Interested to Buy Any Domain ? << Click Here >> for more details...
What are all the problems occured while ac generator
running in leading power factor at full load condition?
- 1 Answers
- 2544 Views
- I also Faced
- E-Mail Answers
Answer Posted / e.subhash
The generator current goes to higher compare to same load and lagging power factor.
i observed while running generator
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to set relay setting? and example calculation...
how to calculate short circuit current for the busbar
What is the difference b/w fanuc alpha series 16i and 18i controller. what is stand for i
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
What must be the minimum distance maintained between 2 Generators as per International standards?
what type of motor used to move a 1 ton gate? and relate ratings with load.
what is the principle of the single phase energy meter? and,what is the advantages and disadvantages of single phase energy meter?
Can we Co-ordinate relay in Load Break switch?
Draw a SLD of DG distribution up to main LT panel?
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
What are the raitings of Mcb,mccb and Acb in detail ??
how does a liquid starter reduce the starting currents?
How you give clearance to a spare feeder.
what is meant by surge? what we called for high currents?
