Interested to Buy Any Domain ? << Click Here >> for more details...
what should be distance from tapping point to inallation place of instruments?
- 3 Answers
- 6303 Views
- Tasnee Petrochemicals, I also Faced
- E-Mail Answers
Answer Posted / meraj143545@gmail.com
Under 6 mtr should be installed tx
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
why I need valve guard and whats different between guard and positioner ??
sir, give me placement papers and interview quistion of birla group company of copper.
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
give me all the details about the interview and which type of question being asked
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
How hart protocol can be connected with control valves?
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
defination of radial vibration?
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
what is the reason while warning lamp is on while the engine is cranking?
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
Why is the orifice tab provided?
