Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate the size of the conductor for particular
load
- 9 Answers
- 28853 Views
- Eskom, HCL, I also Faced
- E-Mail Answers
Answer Posted / basavaraj
Selection of a cable is
1) Depend on load
2) Find out De-rating factors(its depend on the where we have to laid (Duct,Air,Earth)
3) Length of cable(If cable length is more we have to increase the sectional area .If shorter the length reduce the size of the cable.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Explain the experiment on ward leonard method of a speed control on a dc shunt motor with an suitable circuit diagram.
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
why ct ,cvt should be stored in a vertical position?
various transmission tower like .,D tower ,K.C.O tower ,C.C.O tower,K.C.R tower ,C.C.R tower ,H.C.O tower in different tons.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
which is better to use svc or synchronous condenser why ?
working principles of cf lamp,incandescentlamp and f lamp?
why 5kW motor becomes unbalance if its relay trip 1st time and its set value is 7.0 A
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
What must be the distance between the Earth pit which are grounded from two different sources. Example: Distance between the earth pit for LV Panel-1 & 2
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
What is the earth treantment procedure?
what could be the RMS value and average value of a 4 phase sine wave?
How you calculate the repturing capacity of a HRC fuse
