What is the difference between Optical rotation and Spcefic
optical rotation
Answer Posted / dr. reddy
The optical rotation is the angle through which the plane of polarization is rotated when polarized light passes.
The specific optical rotation is observed angle of optical rotation.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
for inorganic molecules require to do RS, Assay and disso?
Principle of single pan analytical balance
what is the acceptance criteria for enteric coated tablets in 0.1n hcl validation in each parameter?
if tech transfer fails whay require to do?
Describe your field experience sample type collected,sample techniques,field measurements taken and equipment used?
if you get peak in blank then what require to do?
calibrtion procedue of LC-MS
in each media we require to use SLS? how to proceed?
why require to add enzymes in capsules dissolution only? is it require to tablet also?
from where i get mortar pastle for glass bottle crush? it's required for testing of it?
2. Two grams of Benzoic acid are dissolved in 200 ml of water and extracted with 200 ml of diethyl ether. The distribution coefficient of benzoic acid is 100, and its dissociation constant is 6.5 10-5. Calculate the distribution ratio (D) of benzoic acid at pH 2, 5, and 6. 3. Calculate D at pH 2 to 10 (1 unit apart) in the above problem, and plot D versus pH.
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
How to determine the EDTA content by potentiometry titration in Ceftriaxine sodium
in monograph 7 imp are there but in vendor showing 5 imp do not req to include 2 imp for that what will be justification?
How do we get end points and how many end points are possible for citric acid and di-acid not theorotically answer should be given practically.