Interested to Buy Any Domain ? << Click Here >> for more details...
In beams why we give lap in middle of top bars and at edges in bottom bars???
- 2 Answers
- 4802 Views
- I also Faced
- E-Mail Answers
Answer Posted / p1bagul
Bcz to avoid laping on maxi BM and SF
(In bottom bar maxi BM at centre,
And in top bar maxi shear force at Edge )
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is difference between code and standard and specification?
Formula of area of crane hook
a) Difference between Ghol , Chimney & fly ash bricks b)Floor to floor height is 3m , rise=15cm , tread 20 cm , how to design staircase means steps landing
what is the method used for marking of cantilevers in hirise buildings by using theodolite
For The preparation of goverment examination Which book i will prefer and by which way i will do the preparation for exam.
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
use ofr concrete as per grade ?
1) a)to prepare mortar for bricklaying how much amount of water should be added for its maximum strength and workability(to avoid cracks which results, when high quantity of water is added)?is their a formula or ratio? b) suppose we want to make 1:3 mortar,what is the best way to measure cement ,sand and water and how? c)time before which freshly prepared mortar should be used? d)proper way to mix and make mortar? e)when should curing start after laying bricks and for how long?and also how many hours per day? f)what is shear wall (please in terms of layman lol) bookish definisions are confusing.... g) and last,acc to codes what are max no. of course that should be laid in a day.
Suppose you planning to paint newly fabricated workshop building made of structural steel of 10 tons total mass. How many litters paint primer for 1 coat and 2 coat of top coat?
how to calculate reinforcment in staircase cranked beam?
why is M25 and Fe 500 assumed to be most economical? i feel it is not.This is because higher grade of concrete and steel has higher lapping length and anchorage length compared to lower grades..
01. a. Diagram of a slump cone…………… 1 b. Size of Slump Cone…………… 1 c. Volume of a slump cone by av. Dia method…………… 1 d. Volume of a slump cone by av. area method…………… 1 e. Volume of a slump cone by frustrum method …………… 1 f. Angles of slump cone …………… 1 g. Slump measured by slump cone due to…………… 1 h. Slump does not measured by cylinder / cube due to …………… 1 i) ii) i. Slump cone is to be filled in……………………..Layers.
how much to get of BRC lapping in full yield and half yield ?
What is the maximum strength of cub compress strength in one cub testing
what are the types of dimensioning?
