Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / avinash kamboj
4 to 5 ampare
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
can u tell me the promotion from oiller to enginer
my diploma certificate in my higher education college
What is cross over distortion? How it can be eliminated?
Why we use duplex coil and hook switch in telephone system?
bsnl tta exam question
what is the meaning of 5% droop or 7% droop in AVR?
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
if any house we instaled a 1.5 ton ac and its phase cable of wiring is installed but netrual cable of wiring not instaed. my question is that is neutual of house(for other wiring is capable for ac load or a sepeart neutrual wiring required
i need the details about bhel exam.how to apply for that.please send to my email-id.thenmozhi2k7@gmail.com
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
in Contactor opearation Why there is a difference in the values of the operate and release voltage in case AC supply
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
What is the most accurate way of testing ELCB?ELCB is better than RCD?
