how step up transformer step up the voltage and what is the
reason behind it?
Answer Posted / ankit
Emf equation of transformer is
E=4.44f*flux*N
E directly propotional to no. Of turn in winding. So high no. Of turn volatage is high
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
what is ground fault in ACB?
what is feeder bay?
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
if i am in front of transmission line how to know that current direction without any equipment
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
Why arc quenching is used in Diode ?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
While testing a ZCT what parameters have to check or measure?
How you will determine the volume of oil in a particular Distribution transformer.
i have attended the interview on 4th June,08 at Kolkata in IOCL, can anybody tell me what is its result