Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between Welding Transformer and Normal Transformer?.
- 2 Answers
- 5449 Views
- DAE, I also Faced
- E-Mail Answers
Answer Posted / ronak garg
In welding we need high current and low voltage. So basically a welding transformer is a step down transformer. A normal transformer can be a step down or a step up depending on our purpose.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the working principle of a DG Set, Alternator, & exiter
Define demand factor?
What is difference between start imitation and start interlock for 3 phase motor protection ?
give single line diagram of D.G distribution form alternator to main L.T panel?
How could a garment factory benefit from renewable energy
What is the disadvantage in proportional controller?
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
generally in LT and MV motors we are using 3.5Coresx16,25,35,50 etc cable for supply.although motors is earthed at two point and having all protection.then why we are using that 1/2 core for earthing the motors.while in HT cable we are using only 3core cable for motor supply.generally lt and mv motors are delta connected and ht motors having star connection.whethere it is having any relation with winding connection( star or delta).all motors i am talking about are dol only.can anybody solve my confusion.thanks...
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
how to test reverse power trip?
what is meant by impedance & transient protection?
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
what are the dimensions for 200 kva transformer plinth (plateform),in which pcc m20 is used..
hi can anyone pls tell me the eee interview core questions asked in l&t
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
