Interested to Buy Any Domain ? << Click Here >> for more details...
What is an Isolation Transformer? Where it will use?
- 3 Answers
- 5729 Views
- I also Faced
- E-Mail Answers
Answer Posted / nagesh.patwari
Isolation transformers block transmission of the DC component in signals from one circuit to the other, but allow AC components in signals to pass. Transformers that have a ratio of 1 to 1 between the primary and secondary windings are often used to protect secondary circuits and individuals from electrical shocks between energized conductors and earth ground. Suitably designed isolation transformers block interference caused by ground loops.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Explain about c.t?
our industries ht line so power fluctation(once drop of power please rectify causes
how to select electronic timer(Star-Delta) setting for diff. rating motors
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
What is reactive power and where it is used.
How RTCC panel is working and give single line diagram for RTCC with transformer?
What type of fittings and electrical accessories can be install in radiation area ?
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
what is the value of combined earthing in general electrical circiut?
What conditions are required for transformer to operate at low frequencies ?
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
For a stable system, where should the poles of a system be in a root loci plot?
i m doing DEEE in part time,can i join regular cources in BE,,IF i join what the cources can i select like (civil,ece,IT) ,,kindly advice
