Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sajid
The Non-coincidence between these loading and unloading curve is know as hysteresis.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
What are the interlocks we have to check during the start up of LP/HP compressor?
Identification of control valve parts.
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
Reason for capillary type dp level transmitter fluctuation
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
NSV type probe stands for
Explain the working principle of lvdt?
what are the values of fuel flow rate in various places in boiler.
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
if my flow is 20000 m3/h than which range of DPT i have to use????
