Where double earthing is required? Is there any power
specification to have double earthing?

Answer Posted / vatsal

As per Indian Standard (IS)3043-1987, it is recommended to use double earthing for medium voltages. Medium voltages are as high as 650V (but should not be lower than 250V). So in case of single phase, it will be usual to have single earthing and for 3 phase it is recommended to have double earthing.

Is This Answer Correct ?    5 Yes 0 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?

2594


In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??

1644


How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?

1597


Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices

1206


What does the term power factor shows?

605






What is slope...? Explain slope 1 and slope 2...?

1084


how load of a turbo generator can be increased

1470


what should be the acceptrd value of winding resistance for 2.5MVA transformer

1850


Testing report of Earthing of 3.15 MVa PTR.

2133


what is difference between earthingpits,earthing grid & earthing mess?

2062


what is th basic difference between a d latch time line and a d flip flop time line???

1473


sir vizag steel ka junior trainee ka paper kitne number ka ayega

1773


Please tell me the earthing procedures adopted for the STAR-STAR 3 Phase transformer in india and give a better sugession for earthing

1511


what is the mechanical safety of DG ?

1693


When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?

1364